3/4-inch veneer edge banding (for wood finish). ![]() 1-by-10-inch-by-6-foot pine board (cut into various sizes).1-by-2-inch-by-8-feet pine boards (MDF boards could work too, but you’d have to cut and paint).Small created her own custom stain color by applying Minwax Driftwood first and then the Varathane Early American finish. Test the stain on both the wood legs and the veneer finish as the two materials may absorb the color differently. Use wood glue and finishing nails to secure all of the leg/frame pieces.Īs Small applied the veneer, she temporarily used PVC pipes underneath, slowly smoothing out the veneer from one end to the other, and thus preventing air bubbles.ĭeciding on the color of wood stain, Small used a mid-tone color to reflect the red oak finish. Repeat the process to make the second supporting piece. ![]() Leave about 1/2 inch (or the width of your plyboard) at the top so that the shelf fits in smoothly. The last piece will go 12 inches above the center, and will serve as a marker for the top. The middle rung will go 16 inches above the bottom. Take two 36-inch long pieces and secure a short piece of wood (this will determine the width of your console) about 5 inches from the ground-this is the bottom. To create the legs, which serve as the frame, cut the wood boards into four equal 36-inch pieces. Apply the edge banding to the front and veneer to the top. You will need a jigsaw to create the curve. Cut three shelves from the plywood to the desired shape and size.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |